What is the proper way to measure length on a dump trailer for a roll tarp?

From outside of front to inside of rear tail gate-measured at the top. Reference the Measuring Diagram .pdf.

What is the standard finished width on a Kwik-Lock replacement Tarp?

10' for a 96" bed, and 10'6" for a 102" bed. This is for a trailer without boards. If it has boards, we will need to get the board height.

What difference do the boards make on roll tarp?

It affects the width of the tarp. Aero Industries will need the board height to configure your replacement tarp properly.

What is the standard finished width on a Classic/Shorty replacement Roll Tarp?

9'8" for a 96", and 10'2" for a 102" trailer. This is also the width without boards.

Which crank folds to the side on a Kwik-Lock System?

The flex crank.

Is a rear cap recommended on a dump trailer for a roll tarp?

It is not recommended, because it is highly susceptible to damage and it limits fork lift access for trailers with two-way tail gates.

What does Aero® need if a customer tries to order a roll tarp that has someone else's caps on it?

We need the finished length and width of the cap because we don't know how far back their caps go. We also need the measurement from outside of front to inside of rear tail-gate to make the tarp to the proper length. Reference the Measuring Diagram.

What information is necessary on a dump trailer front for Aero Industries to configure a roll kit and front cap properly?

For a dump trailer, we almost always need a template; we also need the shape of the dump trailer and whether or not it has a raised dog house or not. If it has a raised dog house, it may be necessary for Aero to see the trailer to take accurate measurements.

How deep is the trough on our aluminum front cap?

Out trough is 10" deep. Reference the Trough and Mounting Lip Diagram .pdf.

How long is the mounting lip on your standard aluminum front cap?

The standard mounting lip on an Aero aluminum front cap is 3". Refrence the Trough and Mounting Lip Diagram.pdf.